Page History

...

On October 20, 2009, an experiment was ran with the set up of influent turbidity around 100 NTU, flocculator length of 2796 cm, flow rate of 5 mL/s, and an alum dosage ranging from 20 to 55 mg/L. The data obtained from this experiment was processed through Mathcad for a simplified overview of the results in graphic form.

There are two important graphs that give the best overview of the experiment: the gamma PDF graph and the residual turbidity graph. The gamma PDF graph shows the probability of reaching a certain floc size for each run of experiment with varying alum dosage. The y-axis represents the probability and the x-axis represents the floc size. The residual turbidity graph is the gamma PDF graph focused at a certain range of sedimentation velocity. We chose this range based on our knowledge on capture velocity. Capture velocity is the minimum speed flocs must be in for them to settle in the sedimentation tank; any particle with a smaller velocity than this will not sink. Given that the capture velocity is 0.12 mm/sec, the residual turbidity graph focuses on the flocs that fail to reach this velocity. The turbidity from these particles shows the resulting turbidity produced after flocculation.

...